Kenwood RC-R0508, Instruction Manual

4

RC-R0508 (En/T)

Remote Control

Getting the most from your remote control

8

Note

Although each setup code is designed to work with a number of
different models, certain codes may not work with some models.
(Also, certain codes may only operate some of the functions available
on a given model.)

• Once registered, the display on the receiver shows the component

type instead of the default input name.
Example: if you register a VCR at the VIDEO 1 jacks, "

VCR

" appears

instead of "

VIDEO 1 

(VCR1)".

• After initial setup, any VIDEO or TV (TV1, TV2, CABLE) inputs that

have not been programmed with a setup code or Non-IR code are
deleted from the cyclic list. The PHONO input will be deleted if a
Non-IR code was not registered.

• The 

INPUT SELECTOR

 on the front panel of the receiver always

cycles through all inputs.

Once setup codes have been entered for all components,
hold down the ENT key until the light flashes twice.

This operation lets you operate the registered components.
KENWOOD audio components with system control turn on and off
automatically with the receiver via the system control connections.

Operating other components

Use the VIDEO, AUDIO, or TV keys to select the compo-
nent you desire.

• Pressing the 

VIDEO

 or 

AUDIO

 key also changes the input selector

on the receiver. If you do not want to change the current input, press
the 

SHIFT

 key before step 

1

.

RC

5

Note

Be sure to point the remote control at the remote sensor on the receiver
when you want to operate KENWOOD components connected by
system control cords. Otherwise, point the remote control at the
component you want to operate.

VIDEO key

1

VIDEO1 (VCR 1)

2

VIDEO2 (VCR 2)

3

VIDEO3 (DVD)
or DVD 6ch

AUDIO key

1

CD (CD)

2

TAPE or MD
(TAPE)

3

TUNER

4

PHONO

TV key

1

TV1

2

TV2

3

CABLE

Press the SHIFT key and then press the POWER key
(within 3 seconds).

• Pressing the 

SHIFT

 key is only required when turning the selected

component on or off. Pressing the 

POWER

 key directly turns the

receiver on and off.

• See "Remote operation of other components" at the end of this

manual for a list of keys available with each component.

RC

$

The remote control mode remains in the set at the component
selected in step 

1

 mode until you select another component

(etc.).

1

2

3

Press the operation keys you desire.

SHIFT

VIDEO, AUDIO, TV

POWER