FM indoor antenna (1)
(T90-0881-08)
Loop antenna (1)
(T90-0882-08)
Remote control unit (1)
(A70-1533-08): DV90K....YX
(A70-1534-08):DV90E.....TE
(A70-1535-08): DV90M....MM2
Batteries (R6/AA) (2)
*AC plug adaptor (1)
(E03-0115-05)
* Use to adapt the plug on the
power cord to the shape of
the wall outlet.
(Accessory only for regions
where use is necessary.)
/
Video cord (1)
(E30-7235-08)
The marking is located on the rear panel and says that
the component uses laser beams that have been clas-
sified as Class 1. It means that the unit is utilizing laser
beams that are of a weaker class. There is no danger of
hazardous radiation outside the unit.
CLASS 1
LASER PRODUCT
The marking of products using lasers
(Except for some areas)
RXD-DV90
2
CONTENTS / ACCESSORIES / CAUTIONS
CONTENTS / ACCESSORIES / CAUTIONS ............. 2
EXTERNAL VIEW .......................................................3
ADJUSTMENT ............................................................4
WIRING DIAGRAM .....................................................5
PC BOARD ................................................................ 6
SCHEMATIC DIAGRAM .......................................... 15
EXPLODED VIEW ....................................................29
PARTS LIST..............................................................31
SPECIFICATIONS ......................................Back cover
Contents
Accessories
SYSTEM
RECEIVER
SPEAKER
SPEAKER
XD-DV90
RXD-DV90
LS-N90V
CRS-N90V
XD-DV90(M2)
RXD-DV90(M2)
LS-N90V
CRS-N90V
XD-DV80
RXD-DV90
LS-N70V
CRS-N90V
XD-DV80(Y)
RXD-DV90
LS-N70V-H
CRS-N90V
XD-DV80(M2)
RXD-DV90(M2)
LS-N70V
CRS-N90V
Operation to reset
The microcomputer may fall into malfunction (impossibility to
operate, erroneous display, etc.) when the power cord is un-
plugged while power is ON or due to an external factor. In this
case, execute the following procedure to reset the microcom-
puter and return it to normal condition.
÷
Please note that resetting the microcomputer clears the
contents stored in and returns and to condition when it left
the factory.
Set the POWE key to ON. Then press the VIDEO/
down.
AUX key while holding the TUNING MODE key
System configurations
Cautions
