5
1
Place the cap over the jacks so that the locking tabs
insert into the transceiver grooves.
2
While holding the cap in place, push it towards the
bottom of the transceiver until the tabs on the cap click
into place.
• To remove the cap, hold the top of the cap in place
with your finger while inserting a
3 mm or smaller flat blade screwdriver under the
bottom of the cap. Slowly slide the screwdriver
in until its tip touches the tab inside the cap, then
gently pry the cap up (handle of screwdriver moving
away from the transceiver) to remove the cap.
1
Insert the speaker/ microphone plugs into the speaker/
microphone jacks of the transceiver.
2
Place the locking bracket over the speaker/
microphone plugs so that the locking tabs insert into
the transceiver grooves.
3
While holding the locking bracket in place, push it
towards the bottom of the transceiver until the tabs on
the bracket click into place.
• To remove the locking bracket, push the bracket
up from the base.
INSTALLING THE (OPTIONAL) SPEAKER/ MICROPHONE
Note:
The transceiver is not fully water resistant when using a
speaker/ microphone or headset.
