TK-2180
6
4. How to Attach the VGS-1
1) Remove the 2 screws.
2) The tip of tweezers is put into the screw hole of the cover
and is pried, the cover will remove.
3) Use the 2 rubber cushions and attach them to the VGS-1.
4) Plug the VGS-1 into the VGS-1 connector of the PC board,
pressing down on the top of the VGS-1 until secure.
5) The spacer turns the adhesive surface down. Next, push
between the chassis and VGS-1.
6) Replace the cover and tighten the 2 screws.
Rubber cushion
(G13-1995-04)
20 x 30 x 1.0 mm
Rubber cushion
(G13-1974-04)
21 x 21 x 2.5 mm
VGS-1
Spacer
(J30-1292-04)
4.5 x 24 x 3.0 mm
VGS-1
VGS-1 connector
DISASSEMBLY FOR REPAIR
2. How to Stick the Sheet (G11-4326-04)
1) Remove the white separation paper of the sheet first (
q
)
and stick the sheet on the front-glass (
w
).
Next, remove the transparent separation paper of the
sheet (
e
).
3. How to Attach the TX-RX Unit
1) In order to attach the TX-RX unit in chassis, don’t put in the
TX-RX unit aslant.
Please level the chassis and the TX-RX unit and attach
them.
Sheet (G11-4326-04)
Front-glass
q
w
e
