BASIC OPERATIONS
1
Turn the
Power
switch
/ Volume
control clockwise to switch
the transceiver power ON.
• A beep sounds if enabled by your dealer.
2
Press the key programmed with the
[Monitor]
or
[Squelch
Off]
function to hear background noise, then rotate the
Power
switch
/ Volume
control to adjust the volume.
3
Rotate the
Channel
selector to select your desired channel.
• When you receive an appropriate signal, you will hear audio
from the speaker.
4
To make a call, press and hold the
PTT
switch, then speak
around the microphone area using your normal speaking voice.
• Hold the microphone approximately .5 inches (3 to 4 cm) from
your lips.
5
Release the
PTT
switch to receive.
Note:
When the battery pack voltage becomes too low, transmission
will stop and an alert tone will sound.
LED Indicator Status
Indicator Color
Meaning
Lights red
Transmitting
Lights green
Receiving a call
Blinks red
Battery power is low while transmitting
Blinks green
Scanning
Blinks orange
/
blue
*
Receiving an encoded call (FleetSync
signaling, etc.)
Blinks red/orange
The selected channel has not been
programmed and cannot be used.
*
Your dealer can set the LED to blink either orange or blue for
FleetSync, DTMF, or 2-tone operation.
