TK-3102G
22
ADJUSTMENT
Controls
Speaker/
microphone
jacks
Antenna
Monitor key
PTT switch
LED indicator
Speaker
Microphone
Power switch/
Volume control
Channel
selector
Frequency
The set has been adjusted for the frequencies shown in
the following table. When required, re-adjust them follow-
ing the adjustment procedure to obtain the frequencies you
want in actual operation.
■
Frequency
CH
K,M
K2,M2
RX (MHz)
TX (MHz)
RX (MHz)
TX (MHz)
1
460.10000
460.00000
480.10000
480.00000
2
450.10000
450.00000
470.10000
470.00000
3
469.90000
469.97500
489.90000
489.97500
4
460.30000
460.30000
480.50000
480.50000
5
460.35000
460.35000
480.55000
480.55000
6
469.40000
469.40000
480.60000
480.60000
7
460.35000
460.35000
480.55000
480.55000
8
460.45000
460.45000
480.65000
480.65000
9~16
-
-
-
-
Preparations for tuning the transceiver
Before attempting to tune the transceiver, connect the
unit to a suitable power supply.
Whenever the transmitter is tuned, the unit must be con-
nected to a suitable dummy load (i.e. power meter).
The speaker output connector must be terminated with
a 8
Ω
dummy load and connected to an AC voltmeter and an
audio distortion meter or a SINAD measurement meter at all
times during tuning.
■
Adjustment Frequency
TEST CH
K,M
K2,M2
RX (MHz)
TX (MHz)
RX (MHz)
TX (MHz)
Low
450.10000
450.00000
470.10000
470.00000
Center
460.10000
460.00000
480.10000
480.00000
High
469.90000
469.97500
489.90000
489.97500
Adjustment Points
Foil side view
TC2
TC203
TC202
TC1
TP2
R222
L212
TC201
TC201, TC202, TC203:
Band-pass
fi lter waveform adjustment
L212:
AF level adjustment
TC1:
Transmit VCO lock voltage adjustment
TC2:
Receive VCO lock voltage adjustment
TP2: Band-pass
fi lter test point
ANT
VR500
VR501
VR1
IC403
CV
SP
MIC
CH
Component side view
ANT: Antenna
connector
CH: Channel
selector
SP: Speaker
jack
MIC: Microphone
jack
CV:
VCO lock voltage adjustment terminal
VR500: DQT waveform adjustment
VR501: MAX DEV adjustment
Note:
To fi ne tune the frequency when not using a
computer, adjust VR1.