Kenwood TK-785, Instruction Manual

10

■

Receiving a Status/Short Data Message Call

1 When a call is received, the   indicator appears on the display and

flashes.

•

The   indicator remains on the display when there is data in the stack.

2 To view the status or message, refer to “Viewing the Stack”, below.

Call Displays

The following messages may appear on the display under certain circumstances:

Holding:

  The transceiver is confirming the call made by the base station.

Engaged:

  The called party is in another call.

Queued:

  All communication channels are currently in use; your status will be

sent when a channel becomes free.

Fail:

  The control station received an invallid call.

NU:

  You entered an invallid call address.

No Reply:

  The called party has been called, but they did not respond to the call.

Call Back:

  The called party has set their transceiver to queue all incoming calls.

Sys Busy:

  The system is currently busy.

Viewing the Stack

1 Press the Status/ Stack key (default is the A key) twice to enter the stack.

•

If there is no data in the stack, “------------” appears on the main display and “-00”
appears on the 3-digit sub-display.

2 Press the

/

(control) keys to view the stack entries.

•

“NEW” represents a new entry, “S” represents a status stack entry, “V” represents a
voice stack entry, and “D” represents a data stack entry.

3 Press the 

C and D

 keys to scroll through the selected entry, to view the

entire entry.

4 To erase an entry, select the desired entry and press the       key.