TKR-850
10
MODIFICATION / DISASSEMBLY FOR REPAIR
w
e
e
r
t
t
q
q
t
t
DISASSEMBLY FOR REPAIR
1. How to Remove the Panel Assy (ABS)
Note :
You can remove the panel assembly (ABS) without
removing the top panel (A62-0840-03).
1. To remove panel (TX-RX,
w
), loose 6 screws (
q
).
2. To remove panel assembly (Front,
r
), loose 6 screws
(
e
).
3. The panel assembly (ABS) is security fastened by 4 tabs
(
t
) on top and bottom. You can remove the panel as-
sembly by pulling to front while you are pulling up the
tabs.
Fig. 5
CN16
CN18
TX-RX unit (A/2)
Component side
Route the coaxial
cable under the lead
wire extending from
CN3 and CN16.
Style the coaxial cable as
illustrated in the figure.
Solder the coaxial
cable.
CN3
E
RX
Final unit (A/2)
Component side
3-2. Connection
1. Solder the prepared coaxial cable to the final unit.
2. Connect the pin connector of the coaxial cable to CN18 of
the TX-RX unit.
3-3. Setting the FPU
Set the channel to be used as “Simplex” using the FPU.
