SIGNALING-2
CTCSS FREQUENCY SCAN
This function scans through all CTCSS frequencies to identify
the incoming CTCSS frequency on a received signal. You may
fi nd this useful when you cannot recall the CTCSS frequency that
the other persons in your group are using.
1
Press
[TONE]
2 times to activate the CTCSS function.
• The icon appears on the display when the CTCSS function is
ON.
•• Each press of
[TONE]
changes the selection as follows:
Tone
(
)
➡
CTCSS (
)
➡
DCS (
)
➡
Cross Tone (
:
default)
➡
Off (no display).
2
Press
[F], [T.SEL] (1s)
.
• The icon blinks and “SCAN” appears on the display.
•
Scan starts when a signal is received.
•
To reverse the scan direction, turn the
Tuning
control clockwise
(upward scan) or counterclockwise (downward scan). You can
also press microphone
[UP]
/
[DWN]
.
•
To quit the scan, press
[ESC]
.
•
When a CTCSS frequency is identifi ed, the identifi ed frequency
appears on the display and blinks.
3
Press
the
Tuning
control to program the identifi ed frequency
in place of the currently set CTCSS frequency.
•
The CTCSS function will remain ON. To cancel CTCSS, press
[TONE]
until CT no longer appears on the display.
• Press
[ESC]
if you do not want to program the identifi ed
frequency.
• Rotate
the
Tuning
control while an identifi ed frequency is
blinking, to resume scanning.
USING DCS
1
Select your desired band.
2
Press
[TONE]
3 times to activate the DCS function.
• The
icon appears on the display when the DCS function is
ON.
•
Each press of
[TONE]
changes the selection as follows:
Tone
(
)
➡
CTCSS (
)
➡
DCS (
)
➡
Cross Tone (
:
default)
➡
Off (no display).
3
Press
[F], [T.SEL]
.
•
The current DCS code appears on the display and blinks.
4
Rotate
the
Tuning
control to select your desired DCS code.
•
Refer to the table below for the available codes.
•
To exit the DCS code selection, press
[ESC]
.
5
Press any key other than the
Tuning
control and
[ESC]
to
complete the setting.
6
When you are called:
The transceiver squelch opens only
when the selected DCS code is received.
When you make a call:
Press and hold
[PTT]
, then speak
into the microphone.
•
To cancel DCS, press
[TONE]
until DCS no longer appears on
the display.
You can also select a DCS code by using the microphone:
1
Select your desired band.
2
Press
[TONE]
3 times to activate the DCS function.
• The
icon appears on the display when the DCS function is
ON.
•
Each press of
[TONE]
changes the selection as follows:
Tone
(
)
➡
CTCSS (
)
➡
DCS (
)
➡
Cross Tone (
:
default)
➡
Off (no display).
3
Press
[F], [T.SEL]
.
•
The current DCS code appears on the display and blinks.
4
Press the key programmed as
[ENTER]
.
