key
Peek & View™
carriage lever
browning control
reheat button with indicator light
defrost button with indicator light
cancel button with indicator light
crumb tray
cord storage
to use your toaster
1 Plug the toaster into the power
supply.
2 Move the browning control to the
desired setting. Use a low setting
for light toasting and for thin or dry
bread.
3 Insert the bread, muffins, bagels etc.
4 Lower the lever
until it locks. The
‘cancel’ button will illuminate. (The
lever will not stay down unless the
toaster is plugged in).
●
To toast frozen bread, once the
bread is lowered press the ‘defrost’
button. The ‘defrost’ button will
illuminate.
●
To warm toast that’s popped up but
gone cold, lower the toast then
press the 'reheat' button. The
‘reheat’ button will illuminate.
●
Use the carriage lever to lift the toast
to
Peek & View™
at any time
without cancelling the toasting cycle.
●
To
stop
toasting during the cycle,
press the ‘cancel’ button, the toast
will pop up and the ‘cancel’ button
light will go off.
5
Your toast will pop up
automatically
, to raise it higher, lift
the lever.
hints on using your
toaster
●
Select a lower setting for light
browning, for toasting one slice only
or for dry bread.
●
When toasting a single slice of
bread, you may notice a variation in
toast colour from one side to the
other - this is normal.
●
Dry/stale bread toasts more quickly
than fresh bread and thinly sliced
bread toasts more quickly than
thickly sliced bread. Therefore the
browning control should be set at a
lower setting than usual.
●
For best results ensure that the
bread slices are of an even
thickness, freshness and size.
●
In order to achieve uniform browning
we recommend you wait a minimum
of 30 seconds between each
toasting so that the control can
automatically reset. Alternatively
select a lower setting when
additional toasting is carried out.
care and cleaning
1 Before cleaning, unplug your toaster
and let it cool down.
2 Slide out the crumb tray
. Clean,
then replace. Do this regularly:
crumbs can smoke or even burn.
3 Wipe the outside of the toaster with
a damp cloth, then dry.
service and customer
care
●
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
●
using your appliance or
●
servicing or repairs
Contact the shop where you bought
your appliance.
3
