Use the carriage lever to lift the
toast to
Peek & View™
at any
time without cancelling the toasting
cycle.
1 slot setting, only heats what you
need, saving 50% energy.
before using your Kenwood
appliance
●
Read these instructions carefully
and retain for future reference.
●
Remove all packaging and any
labels.
safety
●
Burnt food can catch fire, so:
●
●
never leave your toaster on
unattended;
●
●
keep your toaster away from
anything (eg curtains) that could
catch fire;
●
●
set the browning control lower for
thin or dry bread;
●
●
never warm food with a topping or
filling (eg pizza): if it drips into the
toaster, it could catch fire.
●
●
Clean the crumb tray regularly:
crumbs can smoke or burn.
●
To avoid electric shocks,
never
:
●
●
let the toaster, cord or plug get wet;
or
●
●
put
your hand
or anything metal,
eg a knife or foil, into the toaster.
●
Always unplug the toaster when not
in use, before cleaning or
attempting to clear jammed bread.
●
Never cover your toaster with a
plate or anything else - it could
overheat and catch fire.
●
Never let the cord hang down
where a child could grab it.
●
We recommend that you do not
use your toaster directly under wall
cupboards.
●
External metal surfaces are liable to
get hot especially the top area.
●
Do not move the toaster whilst it is
in operation.
●
Never use an unauthorised
attachment or accessory.
●
We do not recommend using the
toaster for non bread items. For
non bread items that are specifically
recommended for use in a toaster
follow the manufacturer’s guidelines
and cooking instructions. Remove
loose crumbs and clean the crumb
tray before and after use.
●
Never use a damaged toaster. Get it
checked or repaired: see 'Service &
Customer Care'.
●
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper
use, or failure to comply with these
instructions.
before plugging in
●
Make sure your electricity supply is
the same as the one shown on the
underside of your toaster.
●
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
Important – UK only
●
The wires in the cord are coloured
as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
●
The appliance must be protected
by a 13A approved (BS1362) fuse.
●
WARNING: THIS APPLIANCE
MUST BE EARTHED.
Note:
●
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
●
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
before using for the first
time
●
Clip excess cord into the cord
storage clips in the base
.
●
Operate the toaster once on a
medium setting without bread.
(The lever will not stay down unless
the toaster is plugged in).
●
As with all new heating elements,
your toaster may emit a slight
burning smell when it is first
switched on. This is normal and
not a cause for concern.
key
햲
Peek & View™
carriage lever
(with ‘Hi-Rise™’ for extra lift)
햳
cancel button with indicator light
햴
browning control
햵
button with indicator
light
햶
crumb tray
햷
햸
cord storage
to use your toaster
1 Plug the toaster into the power
supply.
2 Move the browning control to the
desired setting. Use a low setting
for light toasting and for thin or dry
bread.
3 Insert the bread, muffins, bagels
etc.
4 Lower the lever
until it locks.
(The lever will not stay down unless
the toaster is plugged in). The
‘cancel’ button will illuminate.
5 To toast a single slice of bread,
place the bread into the
,
lower the carriage lever and press
the
button. The
button will illuminate.
●
Use the carriage lever to lift the
toast to
Peek & View™
at any
time without cancelling the toasting
cycle.
●
To
stop
toasting during the cycle,
press the ‘cancel’ button, the toast
will pop up and the ‘cancel’ button
light will go off.
6
Your toast will pop up
automatically,
to raise it higher, lift
the lever.
hints on using your
toaster
●
Select a lower setting for light
browning or for dry bread.
●
Dry/stale bread toasts more quickly
than fresh bread and thinly sliced
bread toasts more quickly than
thickly sliced bread. Therefore the
browning control should be set at
a lower setting than usual.
●
For best results ensure that the
bread slices are of an even
thickness, freshness and size.
●
In order to achieve uniform
browning we recommend you wait
a minimum of 30 seconds between
each toasting so that the control
can automatically reset.
Alternatively select a lower setting
when additional toasting is carried
out.
care and cleaning
1 Before cleaning, unplug your
toaster and let it cool down.
2 Slide out the crumb tray
. Clean,
then replace. Do this regularly:
crumbs can smoke or even burn.
3 Wipe the outside of the toaster
with a damp cloth, then dry. Do
not use abrasives.
햳
햲
햶
햷
햸
햵
햴
Please also read the additional Important Safeguards in the
accompanying leaflet
