- 6 -
Inserting/taking out T-FLASH CARD
Only use approved and compatible T-FLASH card applicable to the mobile phone.
Approved memory card trade standard is applied; however, certain bands may not be
completely compatible with the mobile phone. Using incompatible memory card may
damage not only the card and the mobile, but also the data stored in the card.
1. Turn off the mobile phone, remove the back cover and take out the battery.
2. Slide the clip of memory card to unlock.
3. Lift the clip, and insert the card into it with the side of golden contacts facing inwards.
4. Put down the clip and slide it to lock in position.
5. Put in the battery and install the back cover.
Charging the battery
Check the model number of the charger before using it to charge the mobile.
Only use approved battery, charger and accessories applicable to the specific mobile
model. Using other types of battery, charger and accessories may violate the certification
or warranty terms of the equipment and may result in danger.
Refer to the dealer for supply of relative approved accessories. Hold the plug to plug out
and cut off the power supply of accessories instead of pulling the power cord.
1. Plug the charger in an AC power socket.
2. Insert the plug contact of the charger at the other end into the jack at the side of the
mobile.
If the battery runs out of electricity, you may have to wait for a few minutes till the
symbol of charging is shown on the screen, and then you can make any call and answer
any call.
The time of charging depends on the charger you used.
Note: Please do not at the same time insert the charger and USB data line, if inserted at
the same time may cause your computer and mobile phone damage (or lead to USB data
cable can not be identified).
Startup and shutdown
Press the key of power supply to start up or shut down the mobile phone.
If it is prompted to input PIN or UPIN, please input the required password (shown as
**** on the screen).
