Kenyon B70200, Owner'S Manual

10

KENYON 

Max Load   

Power Supply 

Plug Type

  Part #

B70200   

1300 Watts   

120V AC 11A 60Hz   

3 prong grounded

cord with GFCI

WARNING:

  If the electrical supply does not meet the product specifications, consult with a

 licensed electrician before proceeding with installation!

Do not remove the GFCI device from the supplied power cord under any circumstance.

Electrical Requirements

Countertop Installation

Your City Grill

™

 is supplied with a factory installed polished stainless steel flange that accepts 

four oval head wood screws for mounting. The trim flange of the grill is designed to hold the unit 

firmly in place in the countertop. If desired, you may seal the edge of the countertop beneath the 

trim flange. We recommend a NON-ADHESIVE such as acrylic latex caulk. This will help reduce 

the chance of damage to the trim flange should the unit need to be removed from the countertop. 

Should you need to remove the unit from the countertop after installation simple take a piece of 

fishing line and run back and forth under the trim flange to break the caulk bond.

WARNING:

Allow a 2 inch (2”) minimum clearance between the bottom of the grill and combustible 

surface located below, ie: the upper edge of a drawer installed below the grill (Fig. 7, page 

12). Failure to provide proper clearances and ventilation may result in a fire hazard.

Check the Electrical Supply Requirements

This product must be installed in accordance with national, state and local electric codes.  The 

following table provides the correct voltage, amperage and frequency that must be supplied to the 

grill.  

The supply must be from an individual grounded circuit that is protected by a circuit breaker and 

rated per the specifications for the model as shown in the table below.