Kenyon Sirocco B81200 Series, Owner'S Manual

4

Rearside of the Cabinet***

max 13 3/16" *
min 10 13/16" *

* Do not consider the Door of the Cabinet
** Add 

4/16"

 when using Spacers

CUT-OUT

7 1/2"

*** Rearside of the Cut-Out for cabinet deeper

than 

13 3/16" (without considering the door)

C

   L

Cabinet
Door

22 

1

/

16

" (24" Model)**

28 

7

/

16

" (30" Model)**

34 

7

/

16

" (36" Model)**

Installation

Figure 4

Figure 5

Prepare the cabinet for installation

• Mark and cut-out the cabinet bottom as shown in figure 3.
• Fit the template, which comes with the hood, on the inner

right side of the cabinet making sure the side with arrows
matches with the lower edge of the cabinet and the rear edge
of the cabinet or cut-out.

• Drill  2 holes 

5

/

64

” (see figure 4 - fixing point 1 and 2) and 1 blind

hole 

15

/

64

” in diameter,  

13

/

64

” in depth.

• Move template to the other side and repeat.
• Make cut-out for duct and conduit, see figure 1.

Prepare the hood for installation

• Remove the hood from packaging, check its condition and

make sure the following pieces are included:
1 hood,
1 registration card
1 instruction manual
1 template
1 transition with damper
1 plastic bag with 4 hood fixing 1 transition fixing
screw and 4 spacers.

• Remove the light shield, unscrew and remove lamps to

prevent damage when installing (see paragraph on “Light
replacement” for details).

• Pull out the slider and remove the grease filters (see paragraph

“To remove the grease filters” for details).

• Fit the transition on the outlet hole of the hood:

This has a bayonet lock and must be fixed to the hood with
one screw  (Figure 5), check the opening and closing of the
damper mounted inside.

Figure 3

Bottom of
the cabinet

Backside of
the cabinet

Backside
border

cutout for
1/2" Conduit
and 5" Duct

Blind hole
(Side Springs
Housing)

Fixing
point 1-2

Fixing
point 1-2

Cabinet
Door

Template

Template