8
Be sure lights are cool before cleaning the hood.
To Clean Filters
• The metal grease filters will last forever.
They are made of anodized aluminum
• It is recommended that the filters be washed at least once a month; they
can be washed by hand or in the dishwasher.
• Drain water through edge holes and let each filter dry thoroughly before
replacing it.
To Remove The Metal Grease Filters
• Turn blower and lights off.
• Push simultaneously the two grease filter handles first upwards, then pull towards
the center and extract the filters Figure 8.
• To reinstall, reverse procedure.
To Clean Hood Surface
• For general care, wipe the outside of the white or black hood with sudsy water
or general kitchen household cleaners, rinse well and dry with clean soft cloth to
avoid water marks.
• Do not use abrasive products.
Hood Cleaning
NOTE: Turn blower and lights off. Make sure the lights are cool. If new lights
do not operate be sure lights are inserted correctly before calling service.
• Remove the light shield Q by pushing simultaneously the two unlocking buttons
R (Figure 9); for safety reasons make sure to remove the light shield from its
suspension slides G.
Attention: When removing, handle the light shield by the glass.
• Pull out fluorescent tube and replace with Philips Type PL-S 9 Watt maximum.
• Refit the light shield.
Lights replacement
Figure 8
Figure 9
R
Q
G
Summary of Contents for Sirocco B81200 Series
