126
Set Style
Description of action
Design Tip:
Use the following on window open/close Set Bit parts to initiate actions in the HMI and Controller. For
example you might want to turn a bit on/off in the controller when the operator enters/exits the setup window. The
Controller would then suspend operations pending the change in setup.
Set ON at window
open
When the window containing this Set Bit Part is opened, the designated Device address is
turned ON.
Set OFF at window
open
When the window containing this Set Bit Part is opened, the designated Device address is
turned OFF.
Set ON at window
close
When the window containing this Set Bit Part is closed, the designated Device address is
turned ON.
Set OFF at window
close
When the window containing this Set Bit Part is closed, the designated Device address is
turned OFF.
Design Tip:
Use the following on window maximize/minimize Set Bit Parts to initiate actions depending a window
state.
Set ON at window
maximized
When the window containing this Set Bit Part is maximized, the designated Device
address is turned ON.
Set OFF at window
maximized
When the window containing this Set Bit Part is maximized, the designated Device
address is turned OFF.
Set ON at window
minimized
When the window containing this Set Bit Part is minimized, the designated Device address
is turned ON.
Set OFF at window
minimized
When the window containing this Set Bit Part is minimized, the designated Device address
is turned OFF.
Design Tip:
Use the following on backlight Set Bit Parts to initiate actions that depend on the screen being active.
For example: A Set Bit part of this type might signal a process to go to “sleep mode” because no one is monitoring
it.
Set ON at backlight
off
When the backlight is turned off, the designated Device address is turned ON.
Set OFF at backlight
off
When the backlight is turned off, the designated Device address is turned OFF.
Design Tip:
Use the following on data entry Set Bit Parts to initiate actions that depend on valid data. For example:
Use a Set ON at enter success to trigger the controller to advance the HMI to the next window.
Set ON at enter
success
When a function key with the ENT attribute is pressed in response to a Numeric Input or
ASCII Input part and the attempt to write the data succeeds, the designated Device
address is turned ON.
Set OFF at enter
success
When a function key with the ENT attribute is pressed in response to a Numeric Input or
ASCII Input part and the attempt to write the data fails, the designated Device address is
turned OFF.
Summary of Contents for MMI-1500
Page 2: ...ii...
