79
Dialog asking for Project password on upload.
7.9.3.2 User Security: Activate User security by selecting the
System Parameters|Security
Tab, and
Security Control
option.
Once user security is enabled, all base
windows have a security level assigned to
them. A window can only be accessed if the
security level or higher for that window is
active.
Note:
The only exception to this is the Startup window. That window comes up when the unit is started. The security
level is still at zero on startup, even if the startup window is set at a higher level. In this case, once the startup window
is closed, a password level change is required to get back to it.
Note:
The HMI only checks the security level when the user tries to change base windows with a “Change window”
Function Key.
Note:
Security does not inhibit Function Popup Windows, Direct Windows, Indirect Windows, and PLC Control Window
Change parts.
Fill in the Password Level fields to set the passwords for each level.
Level
Window Setting
Description
Typical Use
0
Lowest
All have access to these windows regardless of the password.
No Level 1 or 2 windows can be accessed from this level.
Operators and general
personnel
1
Middle
Allows access to level 1 and level 0 windows. No Level 2
windows can be accessed from this level.
Setup and maintenance
personnel
2
Highest
Allows access all levels
Supervisors
Window Setting
Dialog showing the
Security Level
setting.
Summary of Contents for MMI-1500
Page 2: ...ii...
