KEPCO KLP 10-150-3, Quick Start Manual

2

228-1616 REV 2

 102607

KEPCO, INC. 

 " 

 131-38 SANFORD AVENUE 

 "

  FLUSHING, NY. 11355 U.S.A.

  "

  TEL (718) 461-7000

  " 

 FAX (718) 767-1102

http://www.kepcopower.com   

" 

 email: hq@kepcopower.com

DESCRIPTION. 

The KLP Power Supply Series are universal input, automatic crossover, 1200-watt

constant power, voltage/current stabilizers with a full rectangular output characteristic. There are six KLP
-1200 Models and six KLP -1.2K Models (see Table 1). The KLP -1200 Models are GPIB and RS 232
compatible; the -1.2K Models are GPIB and LAN compatible; all models allow remote analog program-
ming. For each model a multitude of virtual models can be configured. The “rated voltage, maximum cur-
rent at rated voltage” and “rated current and maximum voltage at rated current” parameters define the
virtual models available within the limit of 1200 Watts of output power.

UNPACKING. 

This instrument has been thoroughly inspected and tested prior to packing and is

ready for operation. After careful unpacking, inspect for shipping damage before attempting to operate.
Perform the PRELIMINARY OPERATIONAL CHECK. If any indication of damage is found, file an imme-
diate claim with the responsible transport service.

EQUIPMENT SUPPLIED

.

See Table 2.

TABLE 1.  MODEL PARAMETERS

Model number

Rated 

Voltage

Range

(1)

Maximum 

current for 

rated voltage

Minimum

programmable 

current 

Rated 

Current

Range

(1)

Maximum 

voltage for 

rated current

Ripple 

and 

noise
p-p

(2)

Efficiency

@115 Va-c

KLP 10-150-

(3)

0-10V

120A@10V

3.2A

0-150A

8V@150A

75 mV

80%

KLP 20-120-

(3)

0-20V

60A@20V

1.6A

0-120A

10V@120A

75 mV

82%

KLP 36-60-

(3)

0-36V

33.3A@36V

0.8A

0-60A

20V@60A

125 mV

83%

KLP 75-33-

(3)

0-75V

16A@75V

0.4A

0-33.3A

36V@33.3A

125 mV

84%

KLP 150-16-

(3)

0-150V

8A@150V

0.2A

0-16A

75V@16A

125 mV

86%

KLP 300-8-

(3)

0-300V

4A@300V

0.1A

0-8A

150V@8A

300 mV

87%

KLP 600-4-

(3)

0-600V

2A@600V

0.05A

0-4A

300V@4A

400 mV

88%

(1) The maximum current and voltage are constrained by the 1200 watt power limitation.
(2) Bandwidth: 20MHz; low frequency ripple may be higher at loads less than 30 Watts.
(3) Specifications listed apply to both -1200 and -1.2K Models.

TABLE 2.  EQUIPMENT SUPPLIED

ITEM

PART NUMBER

QUANTITY

Source power connector

142-0381

1

Jumper (28 AWG or larger bus wire) for local sensing connections 

172-0298

2

Analog I/O port mating connector

142-0528

1

Documentation CD (includes Documentation and Drivers)

254-0034

1