SELENA
Multifunctional LED Clock
USER MANUAL V32D
KERA TECHNOLOGIES INC. 2013
www.ledclocks.com
15
HALTING the ALTERNATING DISPLAY in the TEXT section
User may
(ON DEMAND) HALT
the alternating display by pressing the
FUN
key at any time. The screen currently on the text
display will remain active until the
TALK
key is pressed.
To scroll quickly through the enabled text screens, press the
TALK
key repeatedly.
IMPORTANT ! Some TEXT modes may NOT be available in some clock models.
ZONE TEXT Setup
SELENA clocks equipped with the alphanumeric TEXT display option can display any custom programmed text, for instance
the time
ZONE name
. The text is stored in a permanent memory and will remain there until changed, even without power.
To
Enable the ZONE TEXT PRESET
mode, enable the function
Fn 86.
The function
Fn 85
must also be
enabled.
NOTE
that the clock programming mode
DOES NOT HAVE TO BE ACTIVATED
to program the ZONE TEXT.
1.
Press the
SET
key to initiate the ZONE TEXT Preset Mode.
The left-most character in the Text display section will begin to flash.
NOTE, that if the character has been previously set as “ “ ( space) it may not show as flashing. Continue to the next
step.
2.
Press the
UP
or
DN
key to preset the character.
Use the
NXT
key to move the flashing cursor to the next position.
3.
When finished programming of all characters, press the
MUTE
key to store the entire text in the internal memory.
4.
To
DISABLE
the text preset mode,
disable the function Fn 86
.
When this function is disabled, the
SET
key will not activate the text preset mode, and may be used normally for all
other timer/counter modes.
5.
If the TEXT / DATE alternating mode was set as active, remember to press the TALK key after the programming of
the text is finished in order to resume the alternating mode.
WAKE -UP ALARM CLOCK Setup
SELENA can be set to function as an
Alarm Clock
and perform programmable Wake-up Alarm for each day until disabled.
To enable the WAKE-UP ALARM mode, make sure that the functions
Fn 39, 31
and all other Timer/Counter and Thermostat
modes are
DISABLED
.
In this mode only HOURS:MINUTES can be set and
during this preset
the display will always operate in the
24-hour format
.
NOTE
that the programming mode
DOES NOT HAVE TO BE ACTIVATED
to preset the Wake-Up Alarm, which may be
performed at any time during the normal clock operation (if Stopwatch or other programmable timers are Not Enabled).
1.
Press the
SET
key to initiate the WAKE-UP ALARM Preset Mode.
2.
Using the
UP
and
DN
keys preset the Alarm HOURS and MINUTES.
Use the
NXT
key to move from minutes to hours and back.
NOTE. To reset the time to 0:00 press the
CLR
key.
3.
When finished, wait for several seconds without pressing any keys. The clock will resume normal operation and a
DOT in the lower-right corner of the display will begin to flash. This is an indication that the Alarm is preset and
active.
4.
TO CANCEL the Wake-Up Alarm, press the
STOP
key at any time during the normal clock operation.
The lower-right decimal point will be switched off in response.
NOTE that the Wake-Up Alarm
may be
activated at any time during the normal clock operation
by pressing the
SET
key.
If the preset Alarm Time is satisfactory, wait for few seconds for the display to return to the regular operation mode. Slow
flashing of the lower-right decimal point will indicate that the alarm is activated.
IMPORTANT.
