SELENA
Multifunctional LED Clock
USER MANUAL V32D
KERA TECHNOLOGIES INC. 2013
www.ledclocks.com
6
NXT
1. After invoking the remote programming mode (by pressing the MUTE 5 times), ACTIVATES
Clock/Temperature data preset mode.
2. During data preset, MOVES the cursor to the next position.
3. During Hi/Lo Temperature Alarm data preset, MOVES to the next alarm data preset.
4. In Function Preset Mode, TOGGLES to Activate/Deactivate selected function.
5. Changes the display brightness when Manual Brightness Control Enabled (Fn 24).
FUN
1. After invoking the remote programming mode (by pressing the MUTE 5 times), ACTIVATES the
Functions Selection Mode.
2. During the data preset, ADVANCES the screen to the next display function (time, date, temperature
etc...) for preset.
3. In models with text, halt the text scanning.
SET
INITIATES the PRESET of Timers/Stopwatch/Thermostat or Counter and text in clocks with text display.
Also used to set the Zone Offset in the multi-zone clocks.
STRT
STARTS/RESTARTS the Timer/Stopwatch/Counter.
In the Programmable Thermostat mode initiates AUTOmatic control.
SCAN
RESUMES the display scrolling ( alternating ) mode during regular operation.
CLR
Clears or Resets specific data.
1. RESETS the Temperature to the current temperature reading while MIN/MAX Temperature or
Programmable Thermostat is on display, .
2. RESETS the latch while Hi/Lo Temperature Alarm is pending and Latched Alarm Mode is activated
(will operate only if temperature is outside Alarm range).
3. CLEARS data to 0 in some Counter/Timer preset modes.
STOP
HALTS the Timer/Stopwatch/Counter operation.
In the Programmable Thermostat mode initiates MANUal control.
HOLD
1. HALTS the display scrolling ( alternating ) mode at the current display during regular operation.
2. SAVES the preset data into memory for the programmable event Timers and Thermostat.
K1, K2, K3, K4
Special operation mode.
(not used in regular clock operation)
NOTE,
that many keys may be operating only in certain conditions of the display or the functions selected. Some keys may not
be active depending upon the model and the installed options.
FUNCTION SETUP Procedure
If other programming was performed previously, wait at least 10 seconds for the time-out of the previous mode
.
All clock Functions and Options ( See “
LIST OF FUNCTIONS”
) can be enabled or disabled by selecting them within the
Function Preset Mode. If not in the Programming Mode already, remember to
first initiate
the Programming mode by pressing
the MUTE key
5 times within appx. 4 seconds
, or by removing and then restoring the supply power.
Always,
before using the Remote Control, remember to press the
CLK
key on the remote to set it to the clock mode.
1.
To initiate the Function Preset Mode press the
FUN
key. The text:
Fn xx
will come on the display, where xx is the
function ID number.
2.
Using the
UP
or
DN
keys select the Function ID Number to be (de)activated ( See “LIST OF FUNCTIONS” ).
3.
Enable / Disable the selected function by pressing the
NXT
key until a DOT in the lower-right corner of the display
comes ON / OFF. When the DOT is OFF, the Function is disabled.
4.
Wait for several seconds without pressing any keys. The clock will resume normal operation.
NOTE,
that some functions may not be available in your particular clock model depending upon the installed options. In such
case any attempt to enable these functions will be ignored by the system.
