NXT-6RK Proximity Reader and Keypad
Installation Guide
Page 6 of 7
P/N: 01217-001 Rev. A
4.3
Verifying RIM Configuration
The corresponding reader type and line control mode LEDs are illuminated during operation. Refer to
the Drawing on page 1 for switch and LED locations, and the Table on page 2 for switch and LED
definitions to confirm your configuration settings.
Table 2: RIM LED Guide
LED
Reader Type
D4
Keri MS Series
Keri factory default setting
D5
Wiegand
D6
NXT-6RK
D7
Wiegand Reader/Keypad Combo
LED Control
D1
single wire LED control – red, green, amber, off
D2
two wire LED control – red, green, amber, off
Keri factory default setting
D3
a
a. This table is valid for RIM Firmware v03.01.06 and later. Please upgrade your firmware as necessary.
single wire LED control – red, green, off
standard setting for Wiegand Readers using a single wire to drive the
LED (no amber)
Communication Active
D8
RS-485 Bus
J2 Reader Power Setting
D10
lit when set for 12 VDC reader power
