4
YKI-03-BA-e-2011
3 Connecting the adapter
After unpacking the adapter, you should decide how the adapter is to be mounted. If you
wish to lay the adapter flat on a table, please attach the adhesive feet to the underside of
the adapter.
The enclosed “Quick Installation Guide” contains descriptions of other assembly options.
The adapter can then be connected to the measuring device and the network. Please
proceed as follows:
⇒
Screw the antenna onto the adapter.
⇒
Connect the adapter using the included or a standard Ethernet network cable to
either your computer directly or the network your computer is connected to.
⇒
Connect the mains adapter to the mains power (plug socket) and to the adapter.
Alternatively, the adapter can by powered over the screw terminals (make sure
the Make sure the “Ready” LED is illuminated.
⇒
Connect the RS-232 port of the device (scales, dynamometer...) to the
RS-232 port of the adapter using an appropriate interface cable.
After connecting the hardware, the device must now be configured appropriately.
