7
5
SET CLOCK
It is only possible to set the correct time, when the heater is
connected to the mains and not burning.
1. Use the Adjustment Keys (
▼
hour /
▲
min.) to set the time.
2. To set the time, press “hour” and “min.” set
buttons. Individual motions will increase the
time by one unit; holding continuously will
raise either the “hour” or “min.” rapidly. After
approximately 10 seconds the blinking will
stop and the setting will be locked. 5 Minutes
after switching off the heater, the information
on the display will disappear and the heater will automatically switch into the stand-by
position.
1. Just press the
button to ignite the heater. The
button will start blinking, indicating
that the ignition procedure has started. This will take a short while.
2. After this time heater will automatically ignite and The button will cease its flashing. The
Operation Lamp will remain alight so long as heater is burning.
NOTE: If using your heater for the first time, or after long term storage, ignition may not
take place on the first try. Press the
button again.
NOTE: Fuel pump may produce an audible operating noise at ignition. This is only
temporary.
IGNITION
2
1
OPERATION
CAUTION : Always make sure that there is sufficient ventilation.
LC-32F (GB) 12.9.3 11:39 AM ページ 5
5
SET CLOCK
It is only possible to set the correct time, when the heater is
connected to the mains and not burning.
1. Use the Adjustment Keys (
▼
hour /
▲
min.) to set the time.
2. To set the time, press “hour” and “min.” set
buttons. Individual motions will increase the
time by one unit; holding continuously will
raise either the “hour” or “min.” rapidly. After
approximately 10 seconds the blinking will
stop and the setting will be locked. 5 Minutes
after switching off the heater, the information
on the display will disappear and the heater will automatically switch into the stand-by
position.
1. Just press the
button to ignite the heater. The
button will start blinking, indicating
that the ignition procedure has started. This will take a short while.
2. After this time heater will automatically ignite and The button will cease its flashing. The
Operation Lamp will remain alight so long as heater is burning.
NOTE: If using your heater for the first time, or after long term storage, ignition may not
take place on the first try. Press the
button again.
NOTE: Fuel pump may produce an audible operating noise at ignition. This is only
temporary.
IGNITION
2
1
OPERATION
CAUTION : Always make sure that there is sufficient ventilation.
LC-32F (GB) 12.9.3 11:39 AM ページ 5
keys. Individual motions will increase the
key to ignite the heater. ON/OFF Lamp will start blinking, indicating
After this time heater will automatically ignite and ON/OFF Lamp will cease its flashing. The
ON/OFF Lamp will remain alight so long as heater is burning.
key again.
