NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
10
7/32 in. (5.5mm) All around
WICK 25/64 IN. (10 mm)
RIM OF WICK
ADJUSTER
(holder)
Wick Cover
Hole
Pin
7
. Remove the four wing nuts
which hold the wick assembly
to the heater and carefully lift
the wick assembly from the
heater.
8
. Replace the wick adjustment knob temporarily.
Turn the knob CLOCKWISE to raise the wick.
9
. Hold the wick assembly up-side-
down, using caution, grasp the
wick cover firmly PULL it off with a
sharp tug. If you have difficulty
doing so, try loosening the wick
cover with a flat blade screwdriver.
C A U T I O N : The inside of wick
cover has sharp teeth. The use of
work gloves is suggested to avoid
injury.
11
. Install the new wick and
insert the 3 pins on a new
wick into the 3 holes on
the wick sleeve in the
upward direction. (See the
arrow marked "
up" on
the wick sleeve)
12
. Push the new wick into the
retainer teeth of the wick
sleeve so that the wick
adheres tightly around the
inside of the wick sleeve,
smoothing out any wrinkles.
10
. Remove the wick by
folding it to the inside.
Then remove the wick
sleeve from the bottom of
the assembly.
13
. Line up the pins with the
slotted holes inside the wick
adjuster. Then lightly press
each of the three pins of the
wick (now attached to the
wick sleeve) toward the
inside insert the three pins
into the slanted grooves of
the wick adjuster. Press on
each of the three pins,
inserting them securely in
the holes.
NOTE : Be sure to check wick height. It should be 3/8”.
14
. The wick height will automatically be set to the correct burning
height of 3/8" (10mm).
NOTE : Turn the wick adjustment knob and check to be sure that
the wick moves up and down freely.
NOTE : DO NOT DISASSEMBLE THE STAINLESS STEEL WICK HOLDER.
