KD GEMINI – INSTALLATION/OPERATION MANUAL
KD Gemini
May-06
4
3.0 INSTALLATION
3.1 IMPORTANT
Read this installation manual thoroughly before installing furnace or starting burner.
Consult local authorities about your local Fire Safety Regulations. All installations must
be in accordance with local state or provincial codes. Improper installation will result in
voiding of warranty.
3.2 CAUTION
DO
NOT
START THE BURNER UNTIL ALL FITTINGS, COVERS AND DOORS ARE
IN PLACE.
DO
NOT
TAMPER WITH THE FURNACE OR CONTROLS CALL A QUALIFIED
BURNER TECHNICIAN.
DO
NOT
STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPOURS AND
LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
3.3 INSTALLATION CODES
INSTALLATION MUST COMPLY WITH THE REQUIREMENTS OF AUTHORITIES
HAVING JURISDICTION. All local and national codes governing the installation of oil
burning equipment, wiring, and venting must be followed. Use only nozzles and
settings shown on the operating decal. Use approved fittings, tubing, fuel tank, oil shut
off valves, etc. Some of the applicable codes are:
CAN/CSA B139
Installation Code for Oil Burning Equipment.
NFPA 31
Installation Code for Oil Burning Equipment.
ANSI/NFPA 90B
Warm Air Heating and Air Conditioning Systems.
ANSI/NFPA 70
National Electrical Code.
CSA C22.1
Canadian Electrical Code.
ANSI/NFPA 211
Chimneys, Fireplaces, Vents and Solid Fuel Burning Appliances.
The latest versions of the above codes that have been approved for use in the location
of the installation must be used.
