- 13 -
7. Continuous Drainage
Open the drainage cap
Insert the water hose into the
continuous drainage port
Continuous Drainage Port
Water Tank
Remove the power supply, take out the water tank, open the drainage cap,
and remove the rubber plug, then insert the water hose into the continuous
drainage port and put back the water tank. Connect the power supply to
start the operation. The outlet of the water hose should be lower than the
continuous drainage port by more than 3.9 inches, and can not be bent.
(Note: The diameter of continuous drainage port is 0.63 inches.)
OPERATION
INSTRUCTION
S
Rubber Plug
Summary of Contents for PD08A-18
Page 13: ...9 OPERATION INSTRUCTIONS...
Page 14: ...10 5 Fault Processing Methods OPERATION INSTRUCTIONS...
Page 25: ......