- 15 -
TROUBLESHOOTING
Check the information below for troubleshooting steps, it will save you
time to resolve issues that may happen with the unit. The list includes
most of the common cases, but not the results of defective unit, crafts or
materials in the unit. If all troubleshooting steps have been exhausted and
the issue is still occurring, please feel free to reach out to Kesnos
Customer Service to get further assistance.
ls the Full Tank indicator
blinking? (The tank is full or
in a wrong position. )
?
This product does not apply to
over hot or cold environment,
the machine will automatically
enter the protection mode. It
is a normal phenomenon.
When running under lower
ambient temperature, the
machine will automatically
defrost, which is a normal
phenomenon. It will restart
dehumification again until the
defrosting process finished.
It is normal the compressor
ceases while defrosting
process. Wait until the
process finished, it will restart
dehumidification again.
Is the room humidity lower or
reaching the preset humidity
level?(When the room
humidity has reached the
preset level, the dehumidifier
will enter Standby Mode and
the indicator on LCD will
flash. )
Please set the humidity
decrease by 5% than the room
humidity or set the humidity to
30%.
Summary of Contents for PD08A-18
Page 13: ...9 OPERATION INSTRUCTIONS...
Page 14: ...10 5 Fault Processing Methods OPERATION INSTRUCTIONS...
Page 25: ......
