If the dehumidifier is still not working properly as expected and the
troubleshooting steps or solutions above may not resolve the issue.
Please unplug the power and shut down the dehumidifier, then contact
Kesnos Customer Service at
.
support@kesnos.com
The dehumidifier is not
positioned levelly.
Clean up the dirt or lint on
the air outlet and intake.
Please check whether the
packing bag of the filter had
been removed and the filter
has been installed correctly.
Continuous Mode.
Do Not set the humidity too
low. Typically, 40-50% are
good for use.
Change humidity setting. Or
change to a higher capacity
dehumidifier.
The float of water tank has
been stuck.
Move the float and let it
swing freely.
The magnet on the float has
come off.
Connect the hose with the
drainage port tightly.
The water tank has not been
installed properly.
Re-install the water tank
properly.
- 16 -
Summary of Contents for PD09D
