16
Power rate models from 8 to 10 KVA.
blocking cover for battery
packs
Handle for battery pack
rack
Fig. 4.
battery pack/s removing.
4.2.5. Vertical -tower type- or rack models
• All the UPSs from KESSUPS 91RT series are designed to assemble
the equipment as tower format -vertical position of the equip-
ment- or rack -horizontal position- for its installation in 19" cabi-
nets.
Follow the instructions stated in the sections related to any of
both possibilities, attending the particular configuration of your
equipment.
• Figures from 5 to 10 show as an example an equipment up to 3
kVA. These illustrations are only for help and orientation in the
steps to follow and they are not particular for any model, because
in practice, the actions to make are the same for all models up to
6 kVA.
8 to 10 kVA models, the connection with battery modules for ex-
tended back up time, it is done through a connector located in
the rear side of the equipment (see figure 11).
• All the instructions relating to connections will detailed later on,
less those ones regarding the battery connection. Therefore, this
section will only describe the works linked with the assembling.
4.2.5.1. Rotation of control panel with lCD
Fig. 5.
Rotation of control panel with lCD over the front cover.
• To make easier the message reading when the equipment is ver-
tically installed, it is advisable to rotate 90º clockwise the control
panel with lCD (see figure 5).
• Also, it is advised to rotate the control panel, if any tower type equip-
ment requires to be assembled as rack. Consider that the rotation of
the control panel will be counter clockwise.
• Proceed as follows:
Remove the front cover as it is stated in section 4.2.5.2
Slightly open the nails of the four trims that hold the control
panel with lCD to the front cover to free it and push inward
"A" to separate both parts.
Rotate it 90º on clockwise "b" and insert it again into the front
cover till click it "C". Check the correct closing of the fixing
nails.
Put the front cover back, in the reverse way as its removing
(see section 4.2.5.2).
90º
"A"
"b"
"C"