1
_en
Installation
eTouch Dispensa / Convoy Premio
The eTouch system Kesseböhmer doesn
´
t use a mechanical key. Therefore no distance between
front and body is required.
After closing the cabinet, eTouch need about 2 seconds to recalibrate. During this time, no operation
takes place.
If by using a front sensor, another cabinet open unplanned, the actuated front sensor was irregular connected
to the unintended opening cabinet. In this case disconnect the unintentionally taught sensor as described
below.
Please use the mounting template for installation the
motor unit and the front sensor.
However, by the use of rubber buffers (about 3mm) at the four corners of corpus, the operation
performance over the whole payload range can be further enhanced.
Please make sure that the corpus is aligned horizontally and protected against fall over.
Please make sure that the front rests flat against the corpus front / rubber buffers
