3
_en
Disonnect front sensor
eTouch Dispensa / Convoy Premio
1.
Unplug the power unit from the power supply and wait for about 10 seconds. By switching on the mains
voltage, the dis-/connecting mode of eTouch drive is started automatically. The drive confirms this by
three short beeps, the green LED lights up.
The drive remains for about 5 seconds in this mode
2.
Once the eTouch drive is in dis-/connecting mode, front sensors can be disconnect. To
this purpose, press briefly on the rubber-membrane of the front sensor with your finger
within the 5 second connecting mode. The drive acknowledges this with three short
beeps. The rack moves backwards and forward again. The actuated front sensor is now
disconnected.
If by mistake the wrong front sensor have been
connected to a motor unit, it is possible to
disconnect the front sensor from the eTouch
drive.
This is done in two easy steps, similar
to connect the front sensor:
