889012120 0000 Page 25 of 27
(3)
Down
Up
Elevation protection sensor
2x
2x
Up Down
!
Auto- Memory- Function
This function allows an automatic movement from the top
and bottom position of your TV set. By pressing the arrow
keys “Down” and “Up” twice the bottom height and the
topmost adjusted lifting position can be reached.
The Auto Memory Function may only be used in
combination with an elevation protection sensor.
Device protection
=
No operator
While the child-proof lock is activated each time a key is pressed it will produce an acoustic signal from
the control unit until the protection is deactivated.
!
“S” key
Automatic activation and deactivation of TV set
The outlet included in the set can be connected with the control unit and will then be automatically activated by it.
See page 23, illustration of control/ Jack “F”
Variant SME installed in furniture
The power supply is activated ca. 80 mm above the bottom position. If the ScreenMotion is moved to at least 80 mm below
the top position (maximum lifting position or lifting limit), the power supply remains activated. If the ScreenMotion is not
completely extended (e.g. only halfway), the control unit deactivates the power supply for safety reasons after one minute.
Thus heat accumulation and any damages to the device resulting from it are prevented.
Free-standing variant
The power supply is activated ca. 80 mm above the bottom position. If the fitting reaches a position below this point the
control unit interrupts the power supply.
Child-proof lock
Press and hold the "S" key (3) for 10 sec. to activate the child-proof lock. The control unit confirms this for you by producing
a two-tone sound. From now on the device will not accept any movement commands. To deactivate, press the "S" key (3)
again for 10 sec.
The controlunit confirms this for you by producing a one-tone sound.
While the child-proof lock is activated each time a key is pressed it will produce an acoustic signal from the control unit until
the protection is deactivated.
