INSTALLATION
fig. 5
fig. 6
3. Optional:
If installing a square fixture, loosen the collar's two outer screws, freeing the collar for
rotation, which then can be aligned to the fixtures per design.
a. Realign the collar using its v-shaped notches and an alignment string or laser.
b. Re-tighten the screws to lock the collar’s new position.
Option 2
MOUNTING WITH BUTTERFLY BRACKETS
1. Reposition emitter chassis
a. Remove the cardboard plug from the D3’s aperture.
b. Carefully remove the optic by turning counter-clockwise and pulling.
Note:
Demonstrate caution when removing wall wash optic due to possible damage.
Note:
If you remove the optic, be careful not to touch the exposed silicone dome on the
emitter.
c. Unlock the tilt lock by pulling it toward the fixture aperture. The tilt lock is the red, horizontal lever
to the right or left side of the emitter chassis body (see
fig. 5
).
d. Unlock the rotation lock by pulling it toward the fixture aperture. The rotation lock is the red,
vertical lever across from the emitter chassis body (see
fig. 6
).
e. Tilt and rotate the emitter chassis to open an unobstructed path to the butterfly bracket openings
on either side of the housing.
Rotation Lock and Release
Locked
Unlocked
Tilt Lock and Release
Locked
Unlocked
continued on next page
8 |
D3
INSTALLATION GUIDE
P/N 3662360 Rev C
© 2019-2020 Ketra, Inc. All rights reserved.
