6
■
Caution:
While assembly of the product keep off children’s reach (Choking hazard - con-
tains small parts).
How to handle the swing
■
Make sure that usage does not commence until the apparatus has been properly assem-
bled and subsequently controlled by an adult.
■
Instruct children on the proper handling of the apparatus and advise them of possible dangers.
■
Remember that the children's natural play instinct and temper may lead to unforeseeable
situations excluding a responsibility of the manufacturers.
■
Although dangers to children during proper use of the apparatus are highly unlikely, all
play on the apparatus should be monitored by an adult.
■
For cleaning and caring the swing only use environmentally friendly and no aggressive or
corroding agents.
■
Regularly grease the moving parts with some drops of oil.
Instructions for Assembly
■
Ensure that you have received all the parts required (see check list) and that they are un-
damaged. Should you have any cause for complaint, please contact your KETTLER dealer.
■
Before assembling the equipment, study the drawings carefully and carry out the operati-
ons in the order shown by the diagrams. The correct sequence is given in capital letters.
■
The fastening material required for each assembly step is shown in the diagram inset. Use the
fastening material exactly as instructed. The required tools are supplied with the equipment.
■
The equipment must be assembled with due care by an adult person. If in doubt call upon
the help of a second person, if possible technically talented.
■
Please note that there is
always
a danger of injury when working with tools or doing ma-
nual work. Therefore please be careful when assembling this machine.
■
Ensure that your working area is free of possible sources of danger, for example don’t lea-
ve any tools lying around. Always dispose packaging material in such a way that it may not
cause any danger. There is always a
risk of suffocation
if children play with plastic bags!
■
Bolt all the parts together loosely at first, and check that they have been assembled cor-
rectly. Tighten the locknuts by hand until resistance is felt, then
use spanner to finally tigh-
ten nuts completely against resistance (locking device).
Then check that all screw connec-
tions have been tightened firmly.
Attention:
once locknuts have been unscrewed they no
longer function correctly (the locking device is destroyed), and must be replaced.
■
For technical reasons, we reserve the right to carry out preliminary assembly work (e.g.
addition of tubing plugs).
■
Waste Disposal:
KETTLER products are recyclable. At the end of its useful life please dis-
pose of this article correctly and safely (local refuse sites).
List of spare parts
When ordering spare parts, always state the full item number, spare-partnumber, the quan-
Assembly Instructions
GB
