Assembly, Operation & Maintenence Instructions
Page 9
Lighting Procedure
Lighting the Barbecue Using the Electric Ignition
The Neo 6 burner barbecue has 2 battery operated igniters to operate the appliance. The sparker on the left
ignites the 4 burners on the left hand side (underneath the hot plate and baking dish). The sparker on the right
ignites the 2 burners on the right hand side (underneath the grill plate). Burners can also be ignited via the
cross over channel. Before attempting to light the barbecue, please ensure that a battery has been placed in the
battery operated igniter. To check for, and replace a battery, the black and silver cap requires removing. The cap
is removed by turning in an anti – clockwise direction. A battery can then be placed into the box and the cap
replaced. The barbecue can then be lit by the following procedure:
1. Press in the appropriate control knob and turn to high.
2. Hold the control knob in and press the appropriate ignition button until the burner ignites.
3. Release the ignition button & continue to hold the control knob in for 10 seconds to activate the flame
safeguard. If the burner fails to ignite within 5 seconds of pressing the ignition button, turn the control
knob to off and allow the unburned gas to dissipate before attempting ignition again (5 minutes). If ignition
continues to fail refer to the “Trouble Shooting” section.
4. To achieve ignition on the remaining burners turn either of the adjacent control knobs to ‘High’, and hold in
for 10 seconds. The burner will ignite from the first burner. Alternatively, repeat the above procedure with a
different control knob and ignition button.
Read all operating instructions before lighting.
Open roasting hood before lighting.
Make sure all gas control knobs are in the ‘Off’ position and open cylinder valve or
connect natural gas.
Turn knob anti-
clockwise to “Hi”
Black & Silver cap
Battery
Ignition box
Fascia Panel - Side View
Lighting the Wok Burner Using The Electric Ignition
The Wok Burner also has a 1 battery operated igniter situated at the front of the Wok Burner servery, which has
the same battery replacement procedure as the barbecue igniter. To ignite the Wok Burner, press and hold the
wok burner igniter button down, so that sparks can be seen at the brass burner. Press the gas control knob in and
turn to the High position. When the gas ignites, release the igniter button. If the burner fails to light, turn the gas
control knob to the Off position, let the gas dissipate for five minutes, and then re-try. If ignition continues to fail
refer to the “Trouble shooting” section.
Manual Ignition
To light the barbecue manually, the fat tray is removed. Any burner can then be lit by a match from below. Once
lit, the fat tray is replaced in position.
