15
Draining Your Brewer
If you wish to drain the brewer, the following steps should be followed:
1.
Power off the brewer and unplug Power Cord.
2.
Turn the brewer around (shut off water and disconnect power supply if
necessary) so the back is facing you.
3.
Unclip the drain hoses from their holders and lower them. Move the
brewer close to the edge of the counter so that the drain hoses overhang.
4.
Place a container under the hoses and remove the Drain Plugs.
CAUTION:
The water may be very hot.
NOTE:
The process to completely drain the brewer takes approximately
3 minutes.
5.
When the flow of water stops replace both Drain Plugs and clip the drain
hoses back into place.
6.
When you power up the brewer again it will display "WAS THE BREWER
DRAINED?"
NOTE:
Answer "YES" to the question and the brewer will
start "PRIMING."
Storage
Drain the hot water tank before storing and ensure that you store your brewer
in a safe and frost free environment. It is suggested to store your brewer in the
upright position. If you store the brewer in a cold environment, you run the risk
of water freezing inside the brewer and causing damage. When you prepare to
use it after storage, we recommend running three cleansing brews without a
K-Cup
®
pod. If you plan to move your brewer to a different location, turn the
brewer off, unplug it and empty both the hot water and cold water tanks. If your
brewer has been in an environment below freezing, please be sure to let it
warm to room temperature for two hours before using.
SECTION 4
Troubleshooting
SITUATION
Brewer does not
have power
Brewer will not
brew when used
for the first time
Brewer will
not brew
Brewing a
partial cup
SOLUTION
• Plug brewer into an independent outlet.
• Check to be sure that it is plugged in securely.
• Make sure that the brewer has been turned on and
LCD Display is illuminated.
• Reset circuit breaker if necessary.
• Plug into a different outlet.
• The brewer must be primed for use by filling the
internal hot water tank before the first brew.
• If the brewer is cold/frozen, wait for two hours for it to
reach room temperature before powering on.
• After placing the K-Cup
®
pod in the K-Cup
®
Pod
Holder, make sure the Handle is lowered completely.
• The Exit Needle may be clogged (refer to page 12).
• If the brewer has been set up, without a cleansing
brew, the first cup may be "oversized" (refer to
page 8). The next cup brewed will be brewed to the
proper selected size.
• The Exit Needle may be clogged (refer to page 12).
• Clean K-Cup
®
Pod Holder Assembly if necessary and
rinse under faucet (refer to page 12).
• If the brewer is alerting you to perform a "DESCALE,"
have your Keurig Authorized Distributor descale the
brewer (refer to page 13).
• If your brewer has been in an environment below
freezing, please be sure to let it warm to room
temperature for two hours before using.
