111 |
P a g e
IGMP Setup Guide: TP-Link TL-SG2428P (Single use only available, not stackable)
4K Systems (KD-IP822, KD-IP922, KD-IP1022)
1.
Power-up the TP-Link network switch.
2.
IMPORTANT
:
Disconnect all the DHCP devices like routers or servers from the TP-Link network switch.
3.
(If you want
factory reset
of the switch) Locate a pinhole “RESET” button at the front center panel of your
TP-Link network switch. Using a paper clip press and hold a reset button for more than 5 seconds and then
release. The factory reset process generally takes 5 minutes to complete
4.
Connect your PC to the TP-Link network switch directly using a network cable.
5.
If you have not done yet, configure your PC’s IP address to the same range as the switch
.
(default subnet of the switch -
192.168.
0
.xxx
).
6.
Enter the switch’s IP address in y
our browser and press ENTER (default IP address -
192.168.0.1
).
7.
Enter username and password (default “
admin
” for both). Then click
Log In.
If this is the first time logging in,
there will be a prompt to create a new password.
Summary of Contents for Enterprise AV KD-IP822DEC
Page 19: ...19 P a g e Back to top ...
Page 77: ...77 P a g e Back to top ...
Page 109: ...109 P a g e Back to top ...
