12 |
P a g e
IGMP Setup Guide: Araknis
4K Systems (KD-IP822/922/1022)
1.
IMPORTANT
:
Disconnect all the DHCP devices like routers, servers from the Araknis network switch.
2.
Locate a pinhole “RESET” button at the front panel left bottom corner of your Araknis network switch. Using
a paper clip press and hold a reset button for more than 10 seconds and then release. Wait while the device
is restarted and ready to use (about 5min).
3.
IMPORTANT
:
At this point all the displays should be displaying distorted randomly flashing video images.
4.
Connect your PC to the Araknis network switch directly using a network cable.
5.
If you have not done yet, configure your PC’s IP address to the same range as the switch (default
192.168.
20
.xxx
).
6.
Enter the switch’s IP address (default is
192.168.
20
.254
) in your browser and press ENTER.
7.
Enter user name and password (d
efault is “
araknis
” for both). Then click
Log In.
8.
Navigate to
Settings
->
System
. Under
IP Address Settings
elect
Static
. Change an IP address to
192.168.
1
.
251
,
Subnet Mask
to
255.255.255.0
,
Default Gateway
to
192.168.1.1
(in this case), and at the
bottom click
Apply
. If you are setting up multiple network switches it is recommended to set first one to
192.168.
1
.
251
, second to
192.168.
1
.
252
, and so on, and each switch must be set individually same way as
described below.
Summary of Contents for Enterprise AV KD-IP822DEC
Page 19: ...19 P a g e Back to top ...
Page 77: ...77 P a g e Back to top ...
Page 109: ...109 P a g e Back to top ...
