17 |
P a g e
IGMP Setup Guide: Cisco SG and SF Series
4K Setup for SG Series
1080p Setup for SF Series
Note:
SF Series is Compatible with KD-IP1080, KD-IP120 AV over IP Systems Only
1.
IMPORTANT
:
Disconnect all the DHCP devices like routers, servers from the Cisco network switch.
2.
Locate a pinhole “RESET” button at the front panel left bottom corner of your Cisco network switch.
Using a
paper clip press and hold a reset button for more than 10 seconds and then release. Wait while the device
is restarted and ready to use (about 5min).
3.
IMPORTANT
:
Make sure the green “SYSTEM”LED next to the pinhole “RESET” button is flashing.
4.
IMPORTANT
:
At this point all the displays should be displaying distorted randomly flashing video images.
5.
Connect your PC to the Cisco network switch directly using a network cable.
6.
If you have not done yet, configure your PC’s IP address to the same range as th
e switch (default
192.168.
1
.xxx
).
7.
Enter the switch’s IP address in your browser and press ENTER (check the user manual for a default IP
address - it is usually
192.168.
1
.254
).
8.
Enter user name and password (check the user manual for a default user name and password; it is usually
“
cisco
” fo
r both). Then click
Log In.
9.
Change Password
screen will appear. Enter old and then new password two times as at the picture below
and click Apply.
Summary of Contents for Enterprise AV KD-IP822DEC
Page 19: ...19 P a g e Back to top ...
Page 77: ...77 P a g e Back to top ...
Page 109: ...109 P a g e Back to top ...
