Page 2
About KD-4AUVRX
➔
Receives real-time Color or Black & White video
➔
KD-AUVTX Extends video up to 4,000 ft using a standard CAT cable when used
with an Active Transmitter (Key Digital Model KD-AUVTX).
➔
KD-4AUVRX extends video up to 2,600 ft when used with a Passive Transmitter
Balun (Key Digital Models KD-PVB and KD-4PUV)
➔
Manual Distance Adjustment switches for optimum picture quality at any length
run up to 4,000 ft.
➔
Built-in interference rejection enables wire bundling with other low-voltage lines
➔
Built-in surge protection, ground loop isolation, gain and loss control, and video
detection
➔
Compatible with CAT5/CAT5e/CAT6/CAT7 cabling
➔
Works with generic power supplies, from DC/AC 9V to 12 V (not included)
Installation and Operation
Before permanently securing the unit for final installation of
cabling behind walls or ceilings, test for proper operation of the
unit and the cables in your system.
Video Connections
➔
KD-4AUVRX features two input options for video reception; a RJ45 port labeled
“UTP In” and a Phoenix Connector labeled “UTP In”. It is recommended that only
one of the two options be utilized as the CAT5/6/7 input.
»
Phoenix Connector:
Secure twisted pair wires into “Video
+” and “Video -” of Phoenix Connector block by loosening
screws, inserting twisted pairs, and tightening screws until
connection is secured. If using shielded CAT cabling, you
may insert shield into Pin 3 of Phoenix Connector.
»
RJ45:
Terminate the incoming CAT5/6/7 twisted pair wires
into your RJ45 connector in the following fashion:
