Page 12
KD-HDMS8x8 IR Remote Command List
Below are listed some of the most common remote commands. A complete list of all IR Remote
commands can be found at the Key Digital website www.keydigital.com
The following commands assume an 8x8 configuration.
»
XX = Output Card Number (Range 01~08) [Outputs 1-8]
»
YY = Input Card Number (Range 01~08) [Inputs 1-8]
»
ZZ = Numeric Keypad Number (Range 00~99)
»
Arrows = Up – Down – Left - Right
»
Power On = “Power On”
»
Power Off = “Power Off”
Switching Commands
Switch Input to Output:
»
To Switch Output and Input cards by numeric keypad:
“R1 – XX – Video Mode – YY”
»
Example: To switch Input 3 to Output 2 press; “R1–02–VideoMode–03
Switch Audio Output Source Type:
»
To Switch Audio source of Output Card by numeric keypad:
“R1 – XX – Audio Mode – ZZ”
»
Where ZZ is: 01 = HDMI
02 = RCA COAX SPDIF
03 = RCA ANALOG
04 = CAT5 AUDIO
»
Example: To switch the audio source for output 2 to CAT5 press; “R1–02–AudioMode–04”
Front Panel Commands Using Remote
The Remote can be used to navigate through the front LCD display options.
½
Use the Left and Right Arrow keys to choose options normally made by rotating the Left Selector.
½
Use the Up and Down Arrow keys to choose options normally made by rotating the Right Selector.
½
Use the ‘R2’ button to enter choices normally made by pushing the Right Selector.
½
Use the ‘R4’ button to enter choices normally made by pushing the Left Selector.
RS-232 Control Codes
»
Baud Rate:
57600
»
Data Bits:
8
»
Parity:
None
»
Stop Bits:
1
»
Flow Control:
None
»
Carriage Return:
Required
Pin 5 – Ground
Pin 3 – Receive
Pin 2 – Transmit
RS-232 cable pin out
