8
›
IR In
: Connect IR Sensor (included) to receive line-of-sight IR from infrared remote
»
Corresponds with Output 2’s IR Out port of the presentation switcher
»
Only the included IR sensors are compatible with KD-X40MRx . Third-party IR Sensors may not be
compatible .
»
Note: There is no IR Out port on compatible wall plate Tx unit KD-X4x1WUTx
»
The IR Sensor receives signals from a 90° angle at up to 30 ft . away .
»
Maximum supported IR burst frequency is 55kHz
»
3 .5mm Mono pinout
»
Tip = IR Signal
»
Sleeve = Ground
»
Ring = 5V Sensor Power
›
RS-232 Terminal
: Connect with control system for pass-thru of bi-directional RS-232 commands
»
Supports baud rate up to 115,200bps
»
Tx pin corresponds with Tx pin of connected wall plate or Presentation Switch .
»
Rx pin corresponds with Rx pin of connected wall plate or Presentation Switch .
›
Power
: 48/1 .04A (50W) Power Supply
»
Provides power to KD-X100MRx and the connected wall plate Tx unit .
»
If KD-X100MRx is integrated with Presentation Switcher, then power supply connection is not
required at KD-X100MRx as power is provided from the Presentation Switcher .
WARNING: Do NOT Connect Power Supply at both KD-X100MRx and KD-UPS52U simultaneaously.
