10
11
The included blinking-type IR Emitter.
The 3.5mm connector is
mono
and it connects to
the
IR Out
port of the Tx or Rx unit.
The sleeve of the 3.5mm Male connector must have good physical contact
with 3.5 mm Female input/output on the KD-X200ProK.
Some 3.5mm Male plugs feature a plastic
sleeve that extends longer than an average
sleeve. This may cause poor grounding
contact. See the example on the left.
Settings
EDID Control
EDID authentication is provided from the KD-X200ProK/ KD-X200POHK Tx unit to
the connected input / source device. The EDID file (AKA “handshake”) is selected
using the EDID Control rotary on the Tx unit and provides a list of compatible video
and audio formats as well as digital data, informing the source device what it should
output. Most sources will comply with a new EDID file without a power-cycle, but
each source may behave differently.
»
Rx Unit / IR Sensor:
»
IR Sensors can be connected directly into the Rx unit’s IR In port, without
the need for an external IR distribution block
»
IR signal on the Tip, with 5V powering of the IR sensor on the Ring.
IR In
Tip
Ring
Sleeve
Typical 3.5mm
Connector-type
Serial IR (Tx)
IR In
N/C
Ground
Mono
IR Sensor (Rx)
IR In
5V
Ground
Stereo
➔
IR Out
:
»
Pass-through from signal of corresponding IR In port or bi-directional RS-232,
as determined by the position of the Control Rotary
»
Driving power: 5V with 32mA minimum current
»
Typically connected with an IR emitter
IR Out
Tip
Ring
Sleeve
Control Rotary Position
Serial IR
IR Out
N/C
Ground
Any
IR Cabling
Your KD-X200ProK includes an IR Sensor and an IR Emitter.
Signal acceptance:
The IR Sensor receives signals from a 90° angle at up to 30 ft.
away. It accepts a maximum IR burst frequency of 55kHz.
Only
the included IR sensors are compatible with the KD-X200ProK/ KD-
X200POHK. Third-party IR Sensors may not work with KD-X200ProK/ KD-
X200POHK.
The included IR Sensor.
The 3.5mm connector is
stereo
and it connects to
the
IR In
port of the Rx unit.
KD-X200ProK_X200POHK_Manual.indd 10-11
11/17/15 12:43 PM
