4
IR Remote Control
The KD-HDSW can also be operated using the IR remote control provided with your unit.
The KD-HDSW switcher features IR sensors on the front and rear of the unit for reception of
the IR signals.
1
2
3
4
1
2
3
R1
4
5
7
8
6
R2
0
9
R3
Device Select
Auto
Power Off
Power On
www.keydigital.com
Input
Power On
Power Off
Auto Input Select
Input Select
Scroll Down
Input Select
Input Select
Scroll Up
R1, R2, R3
Reserved for future use
Numeric Keypad
Used in addressable
mode for specifying
unit’s address
Serial IR & IR Emitter Control
›
The “Serial IR” port requires the use of a Male 3.5mm Mono cable (not included) with the IR
command signal being carried on the “Tip” of the input inserted into the KD-HDSW unit. The
location of the IR signal may vary by control system used. Please verify the location of the IR
signal with your control system.
Ground
Signal
›
When using the IR Emitter / IR Extender (sold separately), the
IR Emitter must be mounted over the IR Sensor on the KD-
HDSW unit. It is recommended that the rear IR sensor of the
KD-HDSW unit be utilized for these applications. One end of
the cable is connected to the IR Receiver / Master Controller
/ IR Extender / IR Connecting Block, while the other end is
mounted over the IR Sensor of the KD-HDSW unit.
Summary of Contents for Phantom KD-HDSW2x1Pro
Page 1: ......
