10
›
Power, Link, Video LEDs
: Indicate system connectivity status
»
Power (
red
) illuminates solid with proper powering from local
connection / presentation switch
»
Link (
blue
) illuminates solid from healthy HDBaseT connectivity with
Rx unit / presentation switch
»
Video (
green
) illuminates solid with active HDMI signal
›
USB Device Port
»
Supports USB2 .0 and previous
»
Used for connecting USB endpoints (ie KD-CAMUSB, keyboard, mouse)
»
Not used for connecting USB hosts (ie computer)
»
Supports connectivity to USB hubs but may not exceed 15 endpoint
devices
»
Provides 5V 500mA power
»
Use USB toggle switch to determine if KD-X4x1WUTx will be used to connect a USB host (USB-B
port) or USB device (USB-A port) . Both host and device are not simultaneously possible .
›
USB Host Port
»
Supports USB2 .0 and previous
»
Used for connecting USB host (ie computer)
»
Not used for connecting USB hosts (ie KD-CAMUSB, keyboard, mouse)
»
Use USB toggle switch to determine if KD-X4x1WUTx will be used to
connect a USB host (USB-B port) or USB device (USB-A port) .
Both host and device are not simultaneously possible .
›
LAN Port
»
Default static IP address is 192.168.1.239, port 23
»
Used to connect with Network Switch and peripheral devices needing
network connectivity and/or TCP/IP control
»
Unit configuration, control, and firmware updates are most commonly
achieved with Key Digital Management Software
™
Pro, download at
›
Reset Pin
»
Push and hold for approximately 10 seconds to restore all settings to
default
»
Front LEDs will turn off and restore during bootup process to indicate
the reset has completed .
