Operation method of bluetooth pairing
:(first turn on the power
switch at the bottom of the keyboard)
① Hold down the FN+1 key for 3 seconds. The keyboard enters
the pairing state, and the digit 1 indicator blinks at short intervals.
② Open mobile device Bluetooth (such as mobile phone), select
BT5.0KB (Win7 system select BT3.0KB)
③ The mobile device is connected, and the pairing is complete.
④ Connect to the second device (e.g. computer). If the mobile
phone is connected to 1, hold down FN+2 for 3 seconds, and the
indicator light of number 2 blinks quickly. Then repeat steps ②
and ③.
⑤ Connect the third device (for example, a laptop), and hold
down the FN+3 combination key for three seconds until the
indicator 3 blinks quickly. Then repeat steps② and ③.
⑥ Now turn on the bluetooth of the three connected devices at
the same time, and switch the device connection by pressing
FN+1/2/3.
Lighting operation instructions
:(there is no hibernation setting
in wired mode)
FN+ESC= Switch to light/backlight mode.
FN+ENTER= Switch the backlight color
FN+Backspace= Turn lights off/on（Turn off the light and enter
power saving mode）
FN + \ | = switch lamp effect mode (light waves, ripples,
raindrops, serpentine, follow, aggregation, sine wave,Colorful
springs, flowers, laser, peaks and turns, colorful vertical and
horizontal, breathing, neon)
FN+~= Enter custom light mode (FN+ ESC exit)
The Caps indicator is a case-sensitive indicator. You can use the
FN+ Caps command to change the color of the indicator, but it
does not participate in the indicator effect.
FN key operation instructions:
FN+1/2/3= Switch to Bluetooth mode
Fn+4= Switch to 2.4g mode. Fn+ 5= Switch to wired mode
Fn+F10= mute Fn+F11= volume - Fn+F12=
Fn+Pgup=Home Fn+Pgdn=End FN+I=Insert
Fn+L= browse the web Fn+ C= my computer Fn+P=Print
FN+Win= Lock/unlock the Win key
Restore factory Settings:
Simultaneously press the four corner
keys of the keyboard for 3 seconds (ESC, Left CTRL, F12, right
arrow)
2.4g pairing operation method
:(first turn on the power switch
at the bottom of the keyboard)
Open the keyboard power switch, short press FN+ 4
4 key light flashing, the receiver into the computer USB port can
be used.
FN+Tab= Switch the sleep time of lights. If the Caps light
blinks once, it will start to sleep if it is not used for 2 minutes.
If the Caps indicator blinks twice, the system starts to sleep if it
is not used for 30 minutes.
FN+ direction up = increase brightness.
FN+ direction down = decrease brightness
FN+ direction left = Slow speed.
FN+ direction right = fast speed
F12 button for battery indicator:
low battery for red
breath.When charged, it breathes green; when full, it turns to
its original color.
MAC:
FN+M (hold down for 2 seconds, and blink for 2 to enter, and
blink for 1 to exit) = Enter MAC mode (switch Alt and Win, right
Alt to win, right CTRL to Alt)
FN+F=MAC Switch between the multimedia key and standard
key in zone F (the keyboard must enter MAC mode first)
Knob operation instructions:
Turn left = turn down the volume,
turn right = turn up the volume
Press down to mute and press again to restore volume
Driver mode of use:
driver programming software can be used
in plug-in mode or wireless 2.4g mode
