Keys Fitness Triumph 7.3t, Owner'S Manual

Assembly

7

Figure 3: Left and Right Upright Installation

Figure 4: Console Installation

4. Install the Left and Right Uprights to the tread-
mill base frame by inserting the upright connect-
ing bracket into base frame as seen in Figure 3,
using Allen Bolt 5/16”-18 x 70 (Qty. 4), Spring
Washer 8 mm (Qty. 4), and Washer 9*16*1.6 mm
(Qty. 4).
Next, install the Allen Bolt 5/16”-18 x 15 (Qty.
6), Spring Washer 8 mm (Qty. 6), and Washer
9*16*1.6 mm (Qty. 6). Refer to Figure 3.

Note:

Do not tighten hardware in step 3 until step

5 is completed.

IMPORTANT, PLEASE NOTE:

While sliding the upright connecting bracket into
the base frame, make sure the harness is installed
inside the upright and pay attention not to pinch
the wire harness.  Excess Console Harness wiring
should be placed inside the Left Upright.

5. Connect the Console Harness together as shown
in Figure 4A.

Note

:  The upright console harness wire should be

inserted through grommet in left upright before
connecting to harness from console assembly.

6.  Connect the Console to the Left and Right
Uprights by sliding the Console connecting brack-
ets into the end of the Left and Right Uprights as
shown in Figure 4. Tighten into place using 5/16”-
18x45 Shoulder Allen Bolt (Qty. 2), Spring
Washer 8 mm (Qty. 2), and Washer 9*16*1.6 mm
(Qty. 2).

LEFT UPRIGHT

LEFT UPRIGHT

RIGHT UPRIGHT

RIGHT UPRIGHT

SPRING WASHER 8 mm

SPRING WASHER 8 mm

SPRING WASHER 8 mm

CONSOLE
HARNESS

WASHER 9*16*1.6 mm

WASHER 9*16*1.6 mm

WASHER 9*16*1.6 mm

ALLEN BOLT
5/16”- 18x70

ALLEN BOLT
5/16”-18x15

CONSOLE

EKG HARNESS

SHOULDER ALLEN
BOLT 5/16”-18x45

Figure 4A: Wiring Harness Installation

IMPORTANT, PLEASE NOTE:

While connecting the Console to the Left and
Right Uprights pay attention not to pinch the wire
harness.

LEFT UPRIGHT

CONSOLE HARNESS

GROMMET