20
Keysight M8132A 640 GSa/s Digital Signal Processor User’s Guide
1
Introduction
•
Trig In LED
- This LED indicates that an externally applied signal
matches the adjusted threshold to be used as a Trigger. The LED turns
on for ~100 ms for each detected edge of the correct polarity. I.e. a
rising edge turns the LED on for 100 ms if the polarity is adjusted to
rising. If the polarity is adjusted to rising and a falling edge is externally
applied, the LED remains OFF. The functionality of this LED is for future
use and is currently not supported.
•
Ref Clk In LED
- This LED is green when a valid signal at Ref Clk In is
detected. In case of invalid signals, it is red. The functionality of this
LED is for future use and is currently not supported.
Related Documents
To access documentation related to the Keysight M8132A Digital Signal
Processor, use one of the following methods:
•
CD
- Browse the product CD for M8132A documentation.
•
Start
>
All Programs
>
Keysight M8131
>
Keysight M8131
Documentation
- Provides links to all product documentation except
for the IVI driver documentation.
•
Start
>
All Programs
>
Keysight Instrument Drivers
>
KtM8131
Digitizer
- Provides link to the product IVI driver help system.
• Go to the product web site (
www.keysight.com/find/M8132A
) and
browse the manuals under
Document Library
tab.
Additional Documents
Additional documentation can be found at:
•
http://www.keysight.com/find/M9502A
for 2-slot chassis related
documentation.
•
http://www.keysight.com/find/M9505A
for 5-slot chassis related
documentation.
•
http://www.keysight.com/find/M9506A
for 5-slot chassis related
documentation.
•
http://www.keysight.com/find/M9514A
for 14-slot chassis related
documentation.
•
http://www.keysight.com/find/M9537A
for embedded AXIe controller
related documentation.
•
http://www.keysight.com/products/KF9000A
for KF9000A PathWave
FPGA related documentation.