Keysight E1412A 6 1/2 Digit Multimeter
Service Guide
75
8
Service
Introduction
This chapter contains information for servicing the Keysight E1412A multimeter.
Equipment Required
You will need an ohmmeter to make continuity checks on fuses F750 andF752
which are the only user replaceable components on the PC board. To avoid
damage to the screw head slots, use Torx drivers as specified in the instructions.
The Torx drivers needed are T8 and T10 (Keysight part numbers 8710-1673 and
8710-1284, respectively).
Service Aids
Service aids on printed circuit boards include pin numbers, some reference
designations, and assembly part numbers. See Chapter 6 for descriptions and
locations of Keysight E1412A (Table 6-1) replaceable parts.
Do not perform any of the service procedures shown unless
you are a qualified
,
service-trained technician
,
and have
read the WARNINGS and CAUTIONS in Chapter 1 (and the
Warnings and safety information preceding chapter 1)
.
Summary of Contents for E1412A
