Step 3 – Configure the data logger properties
Press
Logging
to display the Logging properties field.
– Leave the default Duration and Sample Period at 30 s and 200 ms respectively.
– Set the Trigger Source to Run/Stop Key by pressing
Trig Src Key
.
Step 4 – Turn on Output 1, start the sequencing and log the data.
Press
Back
to return the display to the data logger view.
– Press Output 1
[On]
to turn on Output 1.
– Press
Run Stopped
to run the data logger. The data logger will be initiated and Output 1 trace is displayed on the
screen.
– Press
Output LIST
>
Run Stopped
to start output sequencing.
The data logger will run for 30 seconds and log the voltage data from output 1. When the data log completes, you
should see the output waveform displayed as follows:
A message will indicate that the logged data has been saved in a file named default.dlog. If you wish to save the data
under a different filename, you must specify the filename before the data logger runs.
Press
File Name
located at the data logger Properties menu to specify a filename.
82
Keysight E36300 Series User's Guide
